Furnace repair in York, PA
If your furnace won’t start, blows cold air, short-cycles or makes new noises, call Anytime Heating & Cooling at (717) 758-8664. We repair gas, oil and propane furnaces from every major brand across greater York, PA, and we answer 24 hours a day, 7 days a week.
4.9 from 108 Google reviews · Answered 24/7
The heating in my home went down last week … I gave them a call and they came out right away. They diagnosed the issue and repaired my unit within 20 minutes. The service and pricing were fantastic.”
Rheem installation specialists. Service for every major brand.
- Rheem
- Carrier
- Lennox
- Goodman
- Daikin
- Mitsubishi Electric
What’s your furnace doing?
Find the symptom closest to yours. These are the usual causes, though only a diagnosis on site confirms it.
Won’t turn on
- Usually caused by
- Thermostat setting or dead batteries, a tripped breaker or furnace switch, a failed igniter or pilot, or a safety limit switch that tripped.
- What we do
- Check power, controls and the ignition sequence, test the safety switches, and find out why one tripped, not just reset it.
Blowing cold air
- Usually caused by
- A dirty flame sensor shutting the burners off, a failed igniter, an overheating furnace from a clogged filter, or a gas supply issue.
- What we do
- Watch a full cycle to see where it fails, then clean or replace the sensor, igniter or other failing part.
Turns on and off constantly
- Usually caused by
- Overheating from a dirty filter or blocked vents, a faulty flame sensor, a poorly placed thermostat, or a furnace too big for the house.
- What we do
- Check airflow and temperature rise, test the sensor and limit switch, and look at how the system is sized.
Banging, squealing or rattling
- Usually caused by
- Delayed ignition (banging), worn blower motor bearings or belt (squealing), a failing inducer motor, or loose panels and ductwork.
- What we do
- Pinpoint the noise, then repair or replace the motor, adjust the burners, or secure what’s loose.
Higher bills, uneven heat
- Usually caused by
- A dirty filter or burners, duct leaks, worn parts working harder, or an aging furnace losing efficiency.
- What we do
- Clean and test the system, check the ductwork, and tell you plainly whether repair or replacement makes more sense.
Sound like yours? Tell us what it’s doing and we’ll find the real cause.
After hours? See emergency service
From our jobs
Real work from our crew around York, not stock photos.

A furnace, ductwork and water heater from one of our basement jobs.
Repair or replace your furnace?
Most furnace problems are a single failed part, and a repair is the right call. These are the general rules of thumb we’ll walk you through.
How old is your furnace?Typical life: 15 to 20 years
Slide to its age to see which side fits
Usually repair if…
- The furnace is under about 15 years old
- It’s one failed part, like an igniter, flame sensor, motor or switch
- It has otherwise run reliably and heats the house evenly
Consider replacing if…
- It’s 15 to 20 years old or more and needs a major repair
- The repair would cost a large share of a new furnace
- It needs repairs every season, or the heat exchanger is cracked
You’ll get both options and the numbers, and the choice is yours.
What customers say about our furnace repair
4.9 from 108 Google reviewsMy furnace started making a loud noise the night before and with the very cold temperatures we were more than a little nervous that we could be without heat. Brandon came the very next day! Great, honest service!”
Lance W. Anytime HVAC was very responsible and helpful when our furnace was struggling to keep up in the cold temperatures. They provided same day service, got us back up and running quickly, all at a fair price.”
Sean O.
FAQ
Furnace repair questions
Browse all our FAQsWhy is my furnace blowing cold air?
The most common causes are a dirty flame sensor that shuts the burners off, a failed igniter, a clogged filter that makes the furnace overheat and shut down its burners, or a problem with the gas supply. Check that the thermostat is set to heat and the filter is clean. If it still blows cold, call for a repair.
Why does my furnace keep turning on and off?
Short-cycling usually means the furnace is overheating from a dirty filter or blocked vents, the flame sensor is faulty, or the thermostat is in a bad spot. A furnace that is too large for the house can also short-cycle.
Do you repair furnaces at night and on weekends?
Yes. We answer 24 hours a day, 7 days a week. Call (717) 758-8664.


